The Guardian Canister vacuums have a blow port under the filter. So you need to remove the filter (on the Guardian Ultra, you have to open the top of the vacuum) by lifting it up the forward.
Sep 5, 2014 - Looking for an owners manual or a parts identification list for a Chicago heavy duty 5 speed drill press, dp-515. Any help would be greatly.
![Chicago dp 515 drill press manual Chicago dp 515 drill press manual](/uploads/1/2/5/3/125364200/444983347.jpg)
Then disconnect the hose from the normal suction end of the unit and plug it into the blower port. Now turn on the vacuum. If the hose is clogged, position the other end of the hose at the suction port. For the Guardian canister, select the high, medium or low force for the motor. Then blow the dust out from under the furniture or use to fill an inflatable. Turn off the vacuum and replace the hose in the usual position and replace the filter when done.
If you are still unable to get the unit to blow out when connected to the exhaust port after attempting to clear the hose, separate the hose, wand and handle. Look down the hose for any object that might be creating a one-way valve. Remove the foreign object.Do the same with the other parts of the unit. Also replace the vacuum bag. If the bag is sufficiently full, the airflow will be reduced through the bag to the exhaust and cause the problem you describe. The Electrolux Guardian Canister Vacuums are part of the Aerus line. The manuals for the vacuums are available here:.
The Guardian Ultra is in the current model section. The Guardian is listed in the Older Model drop-down menu. I hope this helps. Cindy Wells (many canister vacuums have a blower mode when you connect the hose to the exhaust (after the bag) instead of the suction side of the unit.) Aug 17, 2011.
. 2176 Answers SOURCE: I just looked at a breakdown for this tool and it is not that clear. But to get an owners manual you can go to Searspartsdirect.com and type in your model number and look at the same schematici I did and also order a manual for about 7.50. Usually though on a drill press like that it would be a morse taper.
Do you see a slot cut thru the spindle on both sides, if so there should be a tapered key that came with the unit. In that case what you would need to do it put the key in the slot and tap it with a hammer to remove the adaptor and chuck. Let me know if I can help further Posted on Jan 03, 2009.